Arduino Lucky Shield is an easy way to use your Arduino boards, that grants you access to barometric pressure, relative altitude, luminosity, temperature, motion and presence. You can also turn it into a simple controller and OLED display system. It is the perfect shield for IoT.
Operating voltage: 3.3 VDC / 5 VDC LEDs: POWER (Green) . LED1 (Yellow) . LED2 (Yellow) Joystick: 5-directional tact switch Buzzer: MINIMUM SPL 90 dBA RESONANT FREQUENCY 500 Hz Relay: 50000 operations min (NC) at 250VAC, 8A (resistive load) 50000 operations min at 30 VDC, 5A (resistive load) PIR sensor: Encapsulation type TO5, Spectral response 7~14μm, Transmittance ≥77%, Field of view 139º Ambient light sensor: Peak sensitivity wavelength 630nm , Operating temperature -40 ~ +85°C Temperature / humidity: Operating temperature -40 ~ +85°C Pressure sensor: Operating pressure range 300 ~ 1100 hPa Magnetometer: E-compass, Full-scale range ±1000 T, Output data rates (ODR) up to 80 Hz Accelerometer: G-sensor, Ultra-fast data output time, ~700 μs ±8g full-scale range 3-axis, 45° tilt outputs
The shield doesn't need external power. It will be provided by the Arduino base board, through the 5V and 3.3V pins of the base.
The maximum length and width of the Lucky Shield PCB are 2.7 by 2.1 inches,respectively (68.6 x 53.4 mm). Four screw holes allow the Shield to be attached to a surface or case. Note that the distance between digital pins 7 and 8 is 160 mil (0.16"), not an even multiple of the 100 mil spacing of the other pins.
The shield is compatible with all Arduino board 5V and 3.3V standards.