Proto-Screwshield (Wingshield) R3 Kit for Arduino [ada-196]
The next generation Proto-ScrewShield is a dual-purpose prototyping shield. Now only does it have a large 0.1" grid prototyping area but it also extends the Arduino pins to sturdy, secure, and dependable screw terminal blocks. You even get a few bonus terminals for extra GND and four 'free' terminals for whatever connections you wish! New! As of June 23, 2014 we now have an R3 update to this design - we now have a stacking header for the ICSP 2x3 pins and breakout the SCL and SDA pins. It now works much better with R3 UNO's, Mega, Leonardo, as well as stacking nicely with any shield.
The stack-able wing design allows you slip this under any shield and still get easy access to the "analog" & "digital" ports of the Arduino. The ScrewShield can be stacked above or below pretty much every other shield.
1 large high-quality PCB, specifically chosen for its excellent resistance to lots of soldering and desoldering (essential for prototyping boards)
Plenty of prototyping space, with power/ground rails
Diffused green power LED, extra diffused red LED for user choice (although we suggest to connect it to pin 13)
Full set of stacking female header pins
Lots of 3.5mm terminal blocks to fill 36 breakouts on the board
Dimensions: 66mm x 73mm x 10mm (2.6in x 2.9in x 0.4in)
Prior to June 23, 2014 we had an original non-ArduinoR3/Leonardo Screwshield. Since we wanted to add R3/Leonardo/stacking support, the new version repalces two of the GND pins with SCL and SDA so Leonardo users can use I2C. We also include a 2x3 stacking header so that SPI-shields can be stacked!
※ 공급 제조사는 재고 사정에 따라 동일 사양의 대체상품으로 공급될 수 있습니다.
※ 상기 제품에 첨부된 데이타시트는 참고사항입니다.데이타시트에 표기된 내용에 대하여 본사는 어떠한 기술적인 문의 및 발생하는 문제에 대한 법적인 책임을 지지는 않습니다.
※ 사용자께서는 사용 전 반드시 제품에 대한 테스트 및 확인 절차 후 사용하시기 바랍니다